Lever Blade Removal - SRAM code rsc 2018 Service Manual

L e v e r B l a d e R e m o v a l
DOT fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (e.g. your frame) or printing on the brakes, wipe it off
immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT fluid is not covered under warranty.
1 Pull the hose boot away from the brake body to expose the
compression nut, then slide the boot down the brake hose.
2
Remove the hose compression nut.
Pull the brake hose and compression fitting from the brake lever body.
3 Remove each reservoir cap bolt.
4 Remove the reservoir cap and bladder from the lever body.
N OT ICE
8 mm Flare Nut
T10

Lever Blade Removal

31