SRAM code rsc 2018 Service Manual page 28

8 Install each reservoir cap bolt, then tighten.
9
Cut the hose to install a new barb and compression fitting.
10 Apply DOT grease to the hose barb threads. Thread the hose barb into
the hose until it is flush with the end of the hose.
Do not overtighten the hose barb. Overtightening may cause damage
to the hose liner.
11 Install the compression nut onto the hose.
NOTI CE
T10
SRAM Hydraulic Hose Cutter
T8 DOT Grease
1.1-1.3 N·m (10-12 in-lbs)
T8
Lever Blade Installation 28
2