Table of Contents
Advertisement
Section 4 Component Teardown
Detergent Cavity Assembly Removal
1. Disconnect the washer from the electrical supply,
remove the drawer and the top panel.
2. Disconnect the water valve assembly and the
overflow/vent tube and slide them back.
3. Release wiring harness from the side of housing.
4. Disconnect the detergent dispenser outlet hose.
(See Figure 4-63)
5. Remove the (2) screws holding the housing to the
center brace. (See Figure 4-64)
6. Remove the (2) screws holding the housing to the
console panel. (See Figure 4-65)
Figure 4-63.
Screws
Figure 4-64.
Figure 4-65.
4-16
Hose Clamp
Screws
7. Release the (2) tabs, one on each side, locking the
housing to the console mounting panel.
(See Figure 4-66)
8. Slide the housing back until the tabs of the center
cross bar release and the housing drops down.
9. Disconnect the advanced rinsing technology hose.
(See Figure 4-67)
10. Push down on the tub and swing the front of the
housing toward the center of the washer. Work the
housing out from under the center brace and lift the
housing out. (See Figure 4-68)
Figure 4-66.
Figure 4-67.
Figure 4-68.
Hose Clamp
Hide quick links:
Advertisement
Table of Contents
