Automatic Dispenser - Frigidaire Affinity 6000 Series Service Manual

Automatic Dispenser

The automatic dispenser for detergent, liquid bleach and
fabric softener system is made up of the dispenser cavity,
and a removable drawer with three cavities: one for
detergent, one for bleach and one for fabric softener.
A plastic conveyer is snapped to the bottom of the drawer
to direct the outputs from the bleach and softener
chambers to the dispenser housing outlet channel. This
prevents the mixtures from coming out the front of the
drawer. (See Figure 1-21 & 1-22)
The 2 outlets of the water inlet valve assembly are
inserted into the rear of the automatic dispenser. During
the fi ll cycles, water is directed into the top of the cavity
through 2 inlets. The inlet on the right, as viewed from
the front of washer, is connected to the combination
output of the hot water solenoid and the center cold
water solenoid.
The inlet on the left, as viewed from the front of the
washer, is connected to the cold water solenoid.
In the fi ll cycle, water enters into the top of cavity and is
directed across the top of the cavity by 4 channels: the
dispenser bypass channel, the detergent channel, bleach
channel and the fabric softener channel. The channel that
receives the water is determined by which inlet supplies
the water or if both inlets supply the water.
(See Figure 1-23)
The dispenser advanced rinsing technology channel
receives water whenever the inlet on the right, as viewed
from the front of the washer, is activated.
(See Figure 1-24)
Figure 1-21.
Section 1 Basic Information
Figure 1-22.
Figure 1-23.
Figure 1-24.
1-11