Failure Code Chart - Frigidaire Affinity 6000 Series Service Manual

Failure code
E11 Fill time to long.
E13 Water leak in tub or air leak in air bell.
E21 Water not pumping out fast enough.
E23 Drain pump relay on control board failed.
E24 Drain pump relay on control board failed.
E31 Pressure sensor not communicating with control board.
E35 Pressure sensor indicates water overfill.
E36 Control board problem.
E41 Control board thinks the door switch is open.
E43 Board communications problem.
E44 Board communications problem.
E45 Board communications problem.
E46 Board communications problem.
E47 Board thinks the door PTC circuit is open in spin.
E48 Board thinks the door PTC circuit is closed.
E52 Bad signal from tachogenerator.
E56 High motor current.
E57 High current on inverter.
E58 High current on motor phase.
E59 No tacho signal for 3 seconds.
E5A High temperature on heat sink.
E5B High temperature on heat sink.
E5C High temperature on heat sink.
E5D Communication problem.
E5E Communication problem.
E5F Communication problem.
E66 Heating element relay failure.
E67 Input voltage on microprocessor incorrect.
E68 Current leakage to ground on heater or fuse opened.
E74 Wash temperature does not increase.
E75 Water temperature sensor circuit.
E76 NTC temperature for the cold water valve over the limits.
E82 Console control problem
E83 Console control problem
E91 Selector LEDs do not light up
E93 Console control problem
E94 Console control problem
E95 Communication error.
3-9

Failure code chart

Fault condition
Section 3 Electronic Control
Check
Refer to test (1).
Refer to test (2).
Refer to test (3).
Replace control board or wire.
Replace control board or wire.
Refer to test (4).
Refer to test (5).
Replace the control board.
Refer to test (7).
Replace the control board.
Replace the control board.
Replace the control board.
Replace the control board.
Refer to test (7)
Refer to test (7)
Refer to test (8)
Refer to test (9)
Refer to test (9)
Refer to test (9)
Refer to test (10)
Test first if bad replace
speed control board.
Replace the speed control board.
Replace the speed control board.
Refer to test (11).
Refer to test (11).
Refer to test (11).
Refer to test (14).
Refer to test (15).
Refer to test (14).
Place NTC in correct position.
Refer to test (12)
Hot and cold water hoses switched.
Replace the control board.
Replace the control board.
Refer to test (16)
Replace the control board.
Replace the control board.
Replace the control board.