Electronic Control Board Removal
1. Disconnect the washer from the electrical supply
and remove the console.
2. Lay the console on a soft flat surface, remove the
(5) screws holding the control to the console.
(See Figure 4-24)
3. Lift the control out of the console.
Screws
Figure 4-24.
NOTE
When handling and or replacing a control board it is
important the a technician have a wrist ground strap
on and connected to the cabinet or another grounding
position to prevent static electricity from damaging the
board.
Delay Start Button Removal
1. Disconnect the washer from the electrical supply
and remove the electronic control.
2. With the electronic control removed the delay start
button will lift out. (See Figure 4-25)
Figure 4-25.
Section 4 Component Teardown
Removing the interface board
1. Disconnect the washer from the electrical supply
and remove the electronic control.
2. With the electronic control removed the interface
board will lift out. (See Figure 4-26)
Figure 4-26.
Removing the selector knob
1. Disconnect the washer from the electrical supply
and remove the electronic control.
2. Using a pair of pliers squeeze the knob shaft and
pull the knob out the front of the control panel.
(See Figure 4-27)
Figure 4-27.
4-7