Table of Contents
Advertisement
Error Codes
The electronic control has self diagnostics error codes
built in that cover most products failures.
Reading Error Codes
1. Wake the washer by pressing any button.
2. Wait 5 seconds.
3. Press and hold the START/PAUSE and CANCEL
buttons simultaneously. As long as the buttons are
held, the failure code will appear in the display as
an "E" followed by two numbers, a number and a
letter or two letters. The control will beep and the
Door Lock, Wash, Rinse, and Final Spin indicator
lights will flash.
Quick Check
If there is no error displayed and washer momentarily
starts then turns back off:
1. Listen for a relay closure inside the motor control
shortly after the START/PAUSE key is pressed. If this
happens, the motor control has power.
2. Check the 5 pin connector wiring between the
console control and the motor control.
NOTE
During normal operation, the display may show:
"SAn" - deep clean (Sanitary Cycle)
"cd" - cool down (Sanitary cycle)
"do" or "dr" - door problem.
"Err" - an error has been detected.
"LOC" - control lock is activated.
"PAU" - cycle has been interrupted.
To clear latest stored error code:
•
Turn the Program Knob to start position, Spin Only.
•
Press START/PAUSE to start the cycle and save it.
•
Press CANCEL to stop the cycle and turn off LEDs.
•
Press CANCEL again to turn on the LEDs.
•
Within 5 seconds, press and hold the OPTION and
START/PAUSE buttons until LEDs start sequentially
chasing, then release buttons.
Section 3 Electronic Control
Section 3 Electronic Control
To Clear Latest Stored Error Code
•
Turn the Program Knob to start position, Spin Only.
•
Press START/PAUSE to start the cycle and save it.
•
Press CANCEL to stop the cycle and turn off LEDs.
•
Press CANCEL again to turn on the LEDs.
•
Within 5 seconds, press and hold the OPTION and
START/PAUSE buttons until LEDs start sequentially
chasing, then release buttons.
•
Turn program knob clockwise 7 clicks from Start
Position. The control will signal the last error code.
•
Press and hold the OPTIONS and START/PAUSE
buttons for 3 seconds. The code will be cleared.
•
Exit Diagnostic Mode to return the washer to normal
operation.
a) Unplug the power cord, wait 5-8 seconds, then
reconnect the power cord OR
b) Turn the program knob clockwise 2 or 3 clicks
after the Start Position. Press OPTIONS and
START/PAUSE buttons together for a few
seconds until wash cycle LEDs appear.
3-7
Hide quick links:
Advertisement
Table of Contents
