Table of Contents
Advertisement
Releasing The Bellows (Door Boot) From Front
Panel
The front of the bellows is installed over the lip of the
door opening in the front panel and held in place by a
spring loaded wire loop.
1. Open the loading door.
2. Using needle nose pliers, start where the spring and
wire are connected at the bottom of the bellows and
pull the wire out of the groove of the bellows.
(See Figure 4-15)
3. Pull the bellows off of the lip of the front panel.
(See Figure 4-16)
Figure 4-15.
Figure 4-16.
Door Safety Switch Removal
1. Disconnect the washer from the electrical supply.
2. Release the bellows from the front panel.
3. Remove the (2) screws securing the switch
assembly to the front panel. (See Figure 4-17)
4. Pull the switch assembly into the door opening and
unplug the electrical connectors. (See Figure 4-18)
Lip Of Front
Panel
Section 4 Component Teardown
Screws
Figure 4-17.
Figure 4-18.
Electrical
Connections
4-5
Hide quick links:
Advertisement
Table of Contents
