Frigidaire Affinity 6000 Series Service Manual page 27

Pedestal Installation
5. Set the washer down onto the pedestal making sure
the washer base is behind the front brackets of the
pedestal.
6. Align the sides of the washer with the sides of the
pedestal and attach the washer to the rear brackets
using four #10 screws (2 per bracket) as shown in
Figure 2-11.
7. With pedestal drawer open for better access, install
the two #10 screws through the front brackets
in the pedestal into the washer base as shown in
Figure 2-12.
8. After closing the pedestal drawer, carefully move the
washer/pedestal assembly into position.
NOTE
Because of the increased weight caused by the addition
of the pedestal, two or more people may be required.
9. Excessive noise and vibration can be prevented by
properly leveling the washer/pedestal assembly on a
SOLID floor and tightening the leveling leg lock nuts.
With washer/pedestal assembly in its final position,
place a level on top of washer. Adjust pedestal
leveling legs so the washer/pedestal assembly is
level front-to-rear and side-to side, and stable
corner-to-corner.
Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg so the washer/pedestal assembly is SOLID on the
floor on ALL four pedestal legs. After leveling the
washer/pedestal assembly, adjust the lock nut on
each pedestal leveling leg against the pedestal base
and tighten with a wrench. Keep the leg extension
at a minimum to prevent excessive vibration.
10. Complete the installation following the procedures at
the beginning of this section.
Section 2 Installation Information
Figure 2-11.
Figure 2-12 .
Install Screws
Install Screw
2-9