Verifying Layer 3 Configuration - Cisco aironet 1522 Design And Deployment Manual

Using the GUI to Configure the AP Role
To configure the role of a mesh access point using the GUI, follow these steps:
Click Wireless to open the All APs page.
Step 1
Click the name of an access point. The All APs > Details (General) page appears.
Step 2
Click the Mesh tab (see
Step 3
Figure 40
Choose RootAP or MeshAP from the AP Role drop-down box.
Step 4
Click Apply to commit your changes and to cause the access point to reboot.
Step 5
Using the CLI to Configure the AP Role
To configure the role of a mesh access point using the CLI, enter the following command:
config ap role {rootAP | meshAP} Cisco_AP

Verifying Layer 3 Configuration

Verify that the initial controller that the mesh access point is to associate with is at Layer 3.
To verify that the controller is configured for Layer 3, follow these steps.
Open your web-browser and enter the IP address of your controller. Be sure to precede the IP address
Step 1
with https://. A login screen appears.
Enter your username and password.
Step 2
The default case-sensitive username and password are admin and admin. The summary window appears.
From the top menu bar, click Controller. The controller general window appears.
Step 3
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
Figure 40).
All APs > Details for (Mesh) Page
Connecting the Cisco 1520 Series Mesh Access Point to Your Network
61