Checking the Health of the Network
•
Viewing Neighbor Statistics for an Mesh Access Point
This section explains how to use the controller GUI or CLI to view neighbor statistics for a selected mesh
access point. It also describes how to run a link test between the selected mesh access point and its
parent.
Using the GUI to View Neighbor Statistics for a Mesh Access Point
To view neighbor statistics for a specific mesh access point using the controller GUI, Follow these steps.
Click Wireless > Access Points > All APs to open the All APs window. (See
Step 1
Figure 76
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
130
Re-Association Successes 0
Re-Authentication Failures 0
Re-Authentication Timeouts 0
Re-Authentication Successes 0
To view the number of packets in the queue by type, enter this command:
show mesh queue-stats AP_name
Information similar to the following appears:
Queue Type
Overflows
----------
---------
Silver
0
Gold
0
Platinum
0
Bronze
0
Management
0
Overflows—The total number of packets dropped due to queue overflow.
Peak Length—The peak number of packets waiting in the queue during the defined statistics time
interval.
Average Length—The average number of packets waiting in the queue during the defined statistics
time interval.
All APs Window
Peak length
Average length
-----------
--------------
1
0.000
4
0.004
4
0.001
0
0.000
0
0.000
Figure
76.)
OL-20213-01