Cisco aironet 1522 Design And Deployment Manual page 182

Adding and Managing Mesh Access Points with Cisco WCS
Figure 109
Listed below is a summary of each of the possible Last Reboot Reasons that might be reported and its
definition:
none–Access point reported a reboot reason unknown to the controller
•
dot11gModeChange–Change of 802.11g mode change occurred
•
ipAddressSet–Set of static IP address
•
ip AddressReset–Reset of static IP address
•
rebootFromController–Reboot of access point initiated from the controller
•
dhcpFallbackFail–Fallback to DHCP did not occur
•
• discoveryFail–Discovery was not sent
• noJoinResponse–Join response was not received
• denyJoin–Join attempt at the controller was denied
noConfigResponse–Config Response was not received
•
configController–Configured or master controller found
•
imageUpgrade Success–Upgrade of image successful
•
imageOpcodeInvalid–Invalid image data opcode
•
imageCheckSumInvalid–Invalid image md 5 checksum
•
imageDataTimeout–Image data message timed-out
•
configFileInvalid–Invalid config file
•
imageDownloadError–Process error during the image download
•
rebootFromConsole–Reboot command initiated from AP console
•
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
182
Access Point > AP Name
OL-20213-01