Cisco aironet 1522 Design And Deployment Manual page 103

To enable VLAN tagging on a RAP or MAP using the GUI, follow these steps.
After enabling Ethernet Bridging, click Wireless > All APs.
Step 1
Click the AP name link of the mesh access point on which you want to enable VLAN tagging.
Step 2
At the details window, select the Mesh tab. (See
Step 3
Figure 66
Click the Ethernet Bridging check box to enable the feature and click Apply.
Step 4
An Ethernet Bridging section appears at the bottom of the window listing each of the four Ethernet port
of the mesh access point.An Ethernet Bridging section appears at the bottom of the window listing each
of the four Ethernet port of the mesh access point.
If configuring a MAP access port, click gigabitEthernet1 (port 1-PoE out).
1.
a.
b.
c.
Note
Note
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
All APs > Details for (Mesh) Window
Select access from the mode drop-down menu. (See
Enter a VLAN ID. The VLAN ID can be any value between 1 and 4095.
Click Apply.
VLAN ID 1 is not reserved as the default VLAN.
A maximum of 16 VLANs in total are supported across all of a RAP's subordinate MAPs.
Connecting the Cisco 1520 Series Mesh Access Point to Your Network
Figure 66.)
Figure 67.)
103