Connecting The Cisco Wap125; Verifying The Hardware Installation - Cisco WAP125 Quick Start Manual

4

Connecting the Cisco WAP125

You can perform the initial configuration using either a wired or wireless
connection. The default configuration of the Cisco WAP125 has the Wi-Fi radio
turned on.
To connect the Cisco WAP125 to the wired network:
Connect the Ethernet cable to the Ethernet port of a switch, a router, or a PC.
S 1
TEP
Connect the other end of the network Ethernet cable to the Ethernet port of
S 2
TEP
the Cisco WAP125.
If PoE is not provided, plug in the supplied power adapter to provide power to
S 3
TEP
the Cisco WAP125.
The system provides a one-time-only access to configure the access point using
N
OTE
a wireless connection.
This wireless default configuration will not allow traffic between WiFi and Ethernet;
users will need to go through the setup wizard to resume the traffic between WiFi
and Ethernet.
To connect the Cisco WAP125 to the network wirelessly:
Use wireless clients to locate the WAP125's SSID (CiscoSB-Setup).
S 1
TEP
Use the 'cisco123' passkey to access the access point.
S 2
TEP
After installation, all lights should be active. Refer to
Installation for details about the different lights on the Cisco
WAP125.
5

Verifying the Hardware Installation

To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the state of the indicator light.
Label
Power
4
Activity
Off
Verifying the Hardware
Description
The WAP125 is out of power.
Cisco WAP125 Quick Start Guide