Operation And Technical Data; Light Signals; Emitter Light Signals; Receiver Light Signals - Reer EOS2 A Manual

OPERATION AND TECHNICAL DATA

Light signals

The leds on the Emitter and Receiver light up according to system operating conditions.
Refer to the tables below to identify the various indications (ref. Figure 23).

Emitter light signals

System power-on. Initial TEST.
FAIL condition (Table 18)
Normal operating condition

Receiver light signals

MEANING
System power-on. Initial TEST.
BREAK condition (A)
GUARD condition (C)
FAIL condition (Table 18)
MEANING
System power-on. Initial TEST
BREAK condition (A)
CLEAR condition (B)
GUARD condition (C)
FAIL condition (Table 18)
Table 15 – RX light signals EOS2 (With integrated control functions)
2
The type of fault is identified by the number of flashes (see Troubleshooting chapter)
3
Double blinking (at power-on) of the GREEN led indicates that high range has been selected.
22
EMITTER
Figure 23 - Light signals
MEANING
TEST condition
Table 13 – TX light signals
Table 14 – RX light signals EOS2 / EOS2 Slave
RECEIVER
1
THREE-COLOUR LED
(Red/Green/Orange)
TWO-COLOUR (Red/Green) (2)
RED
RED
GREEN
RED BLINKING
TWO-COLOUR (Red/Green) (2)
RED
RED
OFF
GREEN
RED BLINKING
8540738 • 2nd December 2009 • Rev.2
EOS2 SAFETY LIGHT CURTAIN
2
RED
2
RED BLINKING
ORANGE
3
GREEN
LED
YELLOW (1)
ON
OFF
OFF
OFF
3
LED
YELLOW (1)
ON
OFF
ON
OFF
OFF
3