Pilous ARG 220 D Instruction Manual page 50

Cooling System Cleaning
When coolants are handled, the exposure to dangerous substances cannot be excluded. Observe in your
own interest the instructions and recommendations of the producer or your company referring to safe
coolant handling.
The coolant tank can be removed from the machine base for cleaning and maintenance. The pump is restricted by the length of the
connecting cable). Warning: The used up coolant is special waste!
Our recommendation: Regular cleaning and maintenance of the cooling system extend the life and the functionality of the coolant
pump. Coolants miscible with water, non irritating the skin, highly ageing and corrosion resistant should be used. Oil content in the
coolant should be checked at least once a week. Good lubrication increases the productivity of cutting. Integrated in the coolant tank
is a setting tank, which should be checked in the course of routine checks depending on the material cut.
Hydraulic Unit
The hydraulic unit is maintenance-free. The
recommended within 5000 operating hours. The oil level in the oil level gauge on the hydraulic unit in the machine base should be
consequently checked.
Lubrication
Regular lubrication and cleaning extend the life and the reliability of performance of the machine. While making routine checks, make
sure there is sufficient grease on the vice friction surfaces and the trapezoidal screw and on the friction surfaces of the saw blade
moving bar. Make sure that the measuring bar, the guide bars of the moving vice as well as the vice are thoroughly lubricated (see
figure). Add grease, if necessary.
Pilous band saws are filled with PARAMOL HM 46 oil. The exchange of the oil charge is
Oil level gauge
Measuring bar
Guide rods of moving vice
Discharge opening
IS3 IS1
Lubricating openings
IS3 INDUCTION SWITCH
SETTING SCREW
Slowing-down at moving stop
IS2 INDUCTION SWITCH
IS3
IS1
LED diode
SETTING SCREW
WITH NUT
IS3 INDUCTION SWITCH
SETTING SCREW
Slowing-down in basic position