Pilous ARG 220 D Instruction Manual page 37

GREEN SIGNAL LIGHT
Green signal light is on - the switchboard is live. The MASTER SWITCH is on, the button
TOTAL STOP is unlocked, the saw blade tension and enclosure limit switches are switched
on.
BAND SAW HEAD FEED (only manual mode)
The BAND SAW HEAD FEED switch serves for moving the band saw head in the cutting position
and for moving it back to the upper position after finishing the cut
stopped in any position if the button is switched to .
LEFT VICE (only manual mode)
The switch serves for unclamping or clamping the gripping jaws of the left moving vice.
RIGHT VICE (only manual mode)
The switch serves for unclamping or clamping the gripping jaws of the right moving vice.
SAW BLADE SPEED SWITCH
NC Version
The cutting speed is set with the switch on the control board on the band saw base.
1 - 40 m/min
2 - 80 m/min
Note: The cutting speed may be adjusted only when the motor is switched off
(the saw blade is at standstill). Danger of damage of band saw motor.
SAW BLADE SPEED CONTROLLER
F-NC Version
The cutting speed is adjusted with the saw blade speed controller (through frequency converter)
on the control board arranged on the band saw base.
Continuously adjustable 15 - 90 m/min (can be adjusted during the saw blade run)
.The band saw head can be