Pilous ARG 220 D Instruction Manual page 28

MATERIAL END
MATERIAL END!
Unclamp the right vice
OK
by pressing OK
MATERIAL EXCHANGE!
2 - Kerf
0 - CONTINUE
MANUAL MODE
MANUAL MODE
ESC
1L 6L
2P 7P
3 8
4 9
PRESSURE SWITCH
Pressure switch
Left vice Right vice
It can happen during the cutting procedure that the rest of the workpiece is not
long enough to be clamped correctly. In such an instant, MATERIAL END will be
displayed. Press OK to unclamp the right vice, move it to the right extreme
position; MATERIAL EXCHANGE will be displayed.
When button 2 is pressed, the material kerf takes place again; the machine
continues the cycle, or you can press button 0 to continue the already started
series without a kerf .
MANUAL MODE
Press button 1 to unclamp the left vice.
1L
Press button 2 to unclamp the right vice.
2P
3
Press button 3 to move the band saw head to upper position.
If you press the button once more during elevation, the band saw head will stop.
4
Press button 4 to start the saw blade.
Press button 6 to clamp the left vice.
6L
Press button 7 to clamp the right vice.
7P
8 Press button 8 to move the band saw head to lower position.
If you press the button once more during descent, the band saw head will stop.
9 Press button 9 to stop the saw blade.
Press
Press button
Press button
When the vice clamps, the signal light on the display of the respective vice
switches on, when the vice is unclamped, the signal light goes out. This function is
used especially for setting the moving and fixed vice pressure switches. When
button ESC is pressed, MANUAL MODE is displayed again.
or to move the moving vice in the direction of arrows.
to switch over to MAIN MENU.
to switch over to Pressure switches.