Pilous ARG 220 D Instruction Manual page 33

SETTING OF WORKPIECE PARAMETERS
SETTING
NO. OF PIECES 59
FEED MATERIAL: 5x
Arresting lever
Hand lever
START
Start the machine by using button 1 in MAIN MENU. If more than 1 feed is set, the following will be displayed:
Number of feeds set:
10 x !
4 - Continue
5 - One feed only
PERFORMING
3pcs 10pcs
No.of pcs:
Time: 00:01:15
0 - STOP
3 5
m/min
25m/min 100m/min
35
INTERRUPTED
3pcs 10pcs
No. of pcs:
Time: 00:01:15
0 - CONTINUE
3 5
1 - END
m/min
Finished!
Time: 00:08:25
OK
Machine moves to
basic position.
Please wait.
The system displays the values set.
press button 3 in MAIN MENU: the first edited item PIECES
SETTING
starts blinking.
NO. OF PIECES
Using buttons 1 to 0 on the keyboard set the required number of pieces.
Using the button
Confirm with
Using buttons 1 to 0 on the keyboard set the number of the workpiece
WORKPIECE
feeds. Preset the number of feed if you want to cut pieces longer than
FEED
500 mm, if not, preset the number of feeds 1.
SETTING
Using the button
Confirm with
Setting of required length:
• smaller than 500 mm - set the length with the hand lever; the value will
417 2
be displayed on the digital counter. When the setting is finished, arrest the
set value by the arresting lever. Do not set the offcut; it has been set by the
manufacturer.
• bigger than 500 mm - example of length setting, e.g. 1254 mm.
Depending on the length, enter the number of feeds, in this case 3. deduct
twice the saw blade thickness from the total length, when the system
feeds the workpiece with allowance but not cut takes place 1254-(2x1,3
mm offcut) = 1251,4 mm. Divide this length by the number of feeds
1251,4:3 feeds = 417,13 mm, rounding this value to 417,2 mm. Set this
value on the counter, entering the number of feed 3 on the keyboard.
If the feeds are set correctly, press button 4 to start the machine (the workpiece will be
cut with the preset number of feeds).
If the feeds are set wrong, the button 5 will start the machine only with 1 feed.
PERFORMING The machine works in the preset cycle, informing the operator about the
working condition of the machine.
NO.OF PIECES:
The system informs the operators about the number of pieces cut in the
series just being cut as well as about the total number of pieces cut.
Time: Total cutting time of the series just being cut.
0-STOP The cycle can be stopped with button 0 during the cutting procedure. The
machine finishes the cut, the band saw head is elevated and the saw blade
stops. The display shows INTERRUPTED.
3 5
m/min The actual saw blade speed. The actual saw blade speed is displayed with
the F-NC model. Press the button
over the whole display.Press the button
INTERRUPTED The machine informs the operator about the working condition of the
0-CONTINUE machine.
Press button 0, the machine continues the preset cycle.
1-END
When button 1 is pressed or when the cycle is finished, the display shows
Finished!
Press OK; the following is displayed: Machine moves to basic position.
Please wait.. The moving vice travels to the basic position, MAIN MENU is
displayed.
you can overwrite the preset value.
, the cursor moves to the next item.
you can overwrite the preset value.
and MAIN MENU appears on the display.
; the saw blade speed will be displayed
to switch over to previous menu.