Pilous ARG 220 D Instruction Manual page 40

MANUAL MODE
MANUAL MODE
F1 START
Saw blade speed: 32 m/min
POSITION: 321,5 mm
EDIT
LENGTH: 25,5 mm
Pressure switch
Pressure switch
Left vice Right vice
MATERIAL END
OK
MATERIAL END!
Unclamp the right vice by
pressing OK.
EXCHANGE MATERIAL !
F2 - Kerf
F6 - CONTINUE
MOUNTING OF BUNDLE CUTTING PESSURE DEVICE
Setting
v 1.50 S HVP
F1 - Language: English
F2 - Length unit: mm
Global correction: - 0,2 mm
Operating hours: 08:19:25
CLAMPING A WORKPIECE WITH BOTH VICE JAWS DURING THE CUTTING PROCESS
Setting
v 1.50 S HVP
F1 - Language: English
F2 - Length unit: mm
Global correction: - 0,2 mm
Operating hours: 08:19:25
Press button F1 to move the stop to the preset value shown in item
LENGTH.
F1 START
Current saw blade speed.
Saw blade speed
The system informs the operator about the position of the adjustable
POSITION
stop (the va lue is 0,0 in the basic position).
LENGTH When button
Press
By pressing
The moving vice moves to the preset position.
NOTE: The length is preset in manual mode without material cutoff.
Press button F4 to switch over to Pressure switches.
4
When the vice clamps the workpiece, the signal light on the display of
the respective vice switches on; when the vice is unclamped, the signal
4
light goes out. This function is used especially for setting the moving
and fixed vice pressure switches. When button F4 ESC is pressed,
MANUAL MODE is displayed again.
It can happen during the cutting procedure that the rest of the
workpiece is not long enough to be clamped correctly. In such an
4
instant, MATERIAL END will be displayed. Press F4 to unclamp the
right vice, move it to the right extreme position; MATERIAL
EXCHANGE will be displayed.
When button F2 is pressed, the material kerf takes place again; the
machine continues the cycle, or you can press button F6 to continue
the already started series without a kerf .
If you mount the Bundle cutting pressure device to the machine,
activate the setting of this information in the system by push-button F4
4
HVP will be displayed on the screen. When this device is removed, the
information has also to be deactivated in the system by the push-button
F4 the HVP symbol disappears.
If you need to clamp the workpiece with both vice jaws during the
cutting process, activate the setting via the push-button F3 in the
system S will be displayed after the program version identification. If
you require that the workpiece is clamped only with the fixed vice jaw,
use also the push-button F3 to deactivate the setting in the system the
S symbol will disappear.
is pressed, the cursor starts blinking at 0,0 mm.
to , or to preset the workpiece length.
you can overwrite the preset value. Confirm with
The saw blade cutoff is about 1.3 mm.
.