Pilous ARG 220 D Instruction Manual page 34

MATERIAL END
MATERIAL END!
Unclamp the right vice by
OK
pressing OK..
EXCHANGE MATERIAL!
2 - Kerf
0 - CONTINUE
MANUAL MODE
MANUAL MODE
Saw blade speed: 90 m/min
0 = vice modes
PRESSURE SWITCHES
Pressure switches
Left vice Right vice
MOUNTING OF BUNDLE CUTTING PESSURE DEVICE
Setting
v 1.50 S HVP
1 - Language: English
Operating hours: 08:19:25
CLAMPING A WORKPIECE WITH BOTH VICE JAWS DURING THE CUTTING PROCESS
Setting
v 1.50 S HVP
1 - Language: English
Operating hours: 08:19:25
It can happen during the cutting procedure that the rest of the workpiece is not
long enough to be clamped correctly. In such an instant, MATERIAL END will be
displayed. Press OK to unclamp the right vice, move it to the right extreme
position; MATERIAL EXCHANGE will be displayed.
When button 2 is pressed, the material kerf takes place again; the machine
continues the cycle, or you can press button 0 to continue the already started
series without a kerf .
Press button to switch over to Pressure switches.
When the vice clamps the workpiece, the signal light on the display of the
respective vice switches on; when the vice is unclamped, the signal light goes out.
This function is used especially for setting the moving and fixed vice pressure
switches. When button ESC is pressed, MANUAL MODE is displayed again.
If you mount the Bundle cutting pressure device to the machine, activate the
setting of this information in the system by push-button 4 HVP will be displayed on
the screen. When this device is removed, the information has also to be
deactivated in the system by the push-button 4 the HVP symbol disappears.
If you need to clamp the workpiece with both vice jaws during the cutting process,
activate the setting via the push-button 3 in the system S will be displayed after
the program version identification. If you require that the workpiece is clamped
only with the fixed vice jaw, use also the push-button 3 to deactivate the setting in
the system the S symbol will disappear.