Pilous ARG 220 D Instruction Manual page 39

SETTING OF WORKPIECE PARAMETERS
Up to 30 series with various parameters can be set.
SERIES: 5
EDIT
NO.OF PIECES: 20
LENGTH: 15,0 mm
CORRECTION: 0,5 mm
ACTIVE: NO
On/Off
SERIES: 5
NO.OF PIECES: 20
LENGTH: 15,0 mm
CORRECTION: 0,5 mm
Editing ... O.K.
SERIES: 5
EDIT
NO.OF PIECES: 20
LENGTH: 15,0 mm
CORRECTION: 0,5 mm
ACTIVE: NO
On/Off
START
Start the machine by using button F1 in MAIN MENU. The following information will be displayed.
SERIES: 5 PERFORMING
NO.OF PIECES: 10
LENGTH: 15,0 mm
00:07:28 SERIES: 00:03:45
F4 - STOP
32
F5 - SERIES
m/min
25m/min 90m/min
32
SERIES: 5 INTERRUPTED
NO.OF PIECES: 10
LENGTH: 15,0 mm
00:07:28 SERIES: 00:03:45
F4 - CONTINUE
32
F1 - END
m/min
OK
Finished!
Time: 00:08:25
Press button F3 in MAIN MENU to switch over the system to the
Setting of Workpiece Parameters mode.
The system displays the preset values in series No. 5. If you wish to
SERIES: 5
display further preset values in series 1 - 30, use button
switch over.
Press button F4 EDIT to preset workpiece parameters.
EDIT
4
Press button F4 - the first edited item NO.OF PIECES starts blinking.
NO. OF
PIECES Use buttons
4
Press button
Confirm with
Use buttons
LENGTH:
Press button
Confirm with
If the machine cuts pieces longer that preset, set "- CORRECTION",
CORRECTION:
for shorter pieced "+CORRECTION".
Press
Press
Confirm with
ACTIVATION: Activate or deactivate the series with button F6.
ACTIVATION: YES/NO.
On/Off
SERIES: 5
The system informs the operator, which series is just being cut. The
setting can be checked and editing of different series can be carried out
20
with button F5 during the cutting procedure.
The system informs the operators about the number of pieces cut in the
NO.OF PIECES:
series just being cut as well as about the total number of pieces cut.
LENGTH The system informs the operator about the length of the pieces cut.
00:07:28
Total time of the series finished.
SERIES 00:03:45 Time of the series just being cut.
32
m/min
The actual saw blade speed is displayed with model CF-NC.
Press button F6 to display the saw blade speed over the whole screen.
Switch over to the previous menu by pressing the same button again.
The cycle can be stopped with button F4 during the cutting procedure.
20 The machine finishes the cut, the band saw head is elevated and the
4
saw blade stops. The display shows INTERRUPTED.
The machine informs the operator about the working condition of the
machine. Press button F4 , the machine continues the preset cycle.
4
When button F1 is pressed or when the cycle is finished, the display
shows Finished!
Press OK; the following is displayed: Machine moves to basic
position. Please wait.. The moving vice travels to the basic position,
4
MAIN MENU is displayed.
to ,or to preset the required number of pieces.
to overwrite the preset value.
and the cursor moves to further item LENGTH.
to or to preset workpiece length.
to overwrite the preset value.
and the cursor moves to the next item CORRECTION.
to or to preset the required correction.
to overwrite the preset value.
or to