Pilous ARG 220 D Instruction Manual page 36

Basic Functions
MASTER SWITCH
TOTAL STOP
MODE
The switch serves for switching over between modes:
AUTOMAT - automatic closed cutting cycle for cutting acc. to values set in advance is
implemented by PLC (control unit)
MANUAL - allows for independent control of individual functions
Hydraulic unit START - STOP
When the MASTER SWITCH is on, the HYDRAULIC UNIT - START button activates the
electrical system of the machine and starts the hydraulic unit.
MOVING VICE FEED (only manual mode)
The button MOVING VICE FEED enables the movement of the moving vice on the guide bar in
the direction of arrows.
SAW BLADE START - STOP (only manual mode)
Green button START - serves for starting the band saw motor and the coolant pump.
When the band saw motor is started, the band saw head must be above the switching track of
the end cut limit switch, or else the saw blade drive does not start.
Red button STOP - serves for the band saw motor and the coolant pump shutdown.
RED SIGNAL LIGHT
The red signal light blinks - description of failure on PLC display (control unit)
Ein
Aus
Serves for emergency shutdown of the band saw motor and the
coolant pump.
The machine can be restarted only when the button has been
unlocked manually by pulling!
Make sure before starting the saw blade drive that the
saw blade does not touch the workpiece at the cutting
point.