Pilous ARG 220 D Instruction Manual page 25

Basic Functions
MASTER SWITCH
TOTAL STOP
Hydraulic unit START - STOP
When the MASTER SWITCH is on, the HYDRAULIC UNIT - START button activates the
electrical system of the machine and starts the hydraulic unit.
SIGNAL LIGHT
The red signal light blinks - description of failure on PLC display (control unit)
SAW BLADE SPEED SWITCH
NC Version
The cutting speed is set with the switch on the control board on the band saw base.
1 - 40 m/min
2 - 80 m/min
SAW BLADE SPEED CONTROLLER
F-NC Version
The cutting speed is adjusted with the saw blade speed controller (through frequency converter)
on the control board arranged on the band saw base.
Continuously adjustable 15 - 90 m/min (can be adjusted during the saw blade run)
On
Off
Serves for emergency shutdown of the band saw motor and the
coolant pump.
The machine can be restarted only when the button has been
unlocked manually by pulling!
Note: The cutting speed may be adjusted only when the motor is switched off
(the saw blade is at standstill). Danger of damage of band saw motor!
Make sure before starting the saw blade drive that the
saw blade does not touch the workpiece at the cutting
point.