Install Using Easy Deployment - ASCOM Myco User Manual

User Manual
Ascom Myco Smartphone
For detailed instructions, see the Configuration Manual, Ascom Myco Smartphone.
Follow the instructions in the applicable section:
• 2.2.1 Install Using Easy Deployment, page 5
• 2.2.2 Install Using QR Codes and NFC, page 6
• 2.2.3 Manual Installation, page 7
2.2.1

Install Using Easy Deployment

The handset is automatically installed and configured, if the Wi-Fi system is configured for Easy Deployment.
See the Configuration Manual, Ascom Myco Smartphone for information on how to configure Easy
Deployment in the Wi-Fi system.
Easy Deployment does not automatically provide the handset with a DECT subscription. Before
the handset can be used in DECT environment, the administrator must do one of the following:
• Manually subscribe the handset to the DECT system and log in to an extension manually.
• Enable the DECT Easy Registration feature for automatic DECT subscription and login.
If the handset is successfully installed after the Easy Deployment process, but has not received a
messaging number automatically, do the following:
1. If the handset is turned On, turn it Off and then On again.
2. When the handset displays: "No messaging number configured for this device", tap Setup number.
Figure 1. Handset displaying "No messaging number configured for this device."
3. When the handset displays "Enter messaging number", enter the number.
Caution
If a wrong number is entered, a factory reset must be done, and all handset configuration
parameter settings are restored to the default values. See the Configuration Manual,
Ascom Myco Smartphone
4. Tap Done.
5. If the Unite system is configured for user login, enter the user ID and password supplied by the system
administrator.
TD 93066EN / 14 December 2018 / Ver. N
Quick Installation Steps for Administrators
5