After Use - Cleaning; Emptying, Internal Machine Rinsing, Without Emptying Pump; Emptying, Internal Machine Rinsing, With Emptying Pump - Wexiodisk WD-4C Installation And User Manual

Directions for use

4.3 After use - Cleaning

HACCP is a preventive inspection system to ensure hygiene requirements during
the washing process and cleaning of the machine. Thanks to its design, the ma-
chine meets strict hygiene requirements. From a hygiene point of view, regular
and thorough cleaning is also important. A well-cleaned machine contributes to
excellent cleaning results and reduces the risk of dirt accumulating inside the ma-
chine.

4.3.1 Emptying, internal machine rinsing, without emptying pump

•
•
•
•
•
•

4.3.2 Emptying, internal machine rinsing, with emptying pump

Note: The door must be open when the drain pump is running.
•
•
•
•
•
•
•
•
WD-4C
Turn the knob (1) to position 0. Remove tank filters (7) and the cover plate
(12) from the machine. Empty the water from the machine by removing the
level pipe (11).
Check that no objects have fallen and lodged in the machine.
Close the door and turn the knob (1) to position (3). The internal rinsing pro-
cess starts.
After around 25 seconds, turn the knob (1) back to position 0. Open the
door and check that the washing and rinsing nozzles (13, 14) are clean.
Check that no objects have fallen and lodged in the machine.
Remove and clean the pump filter (8) and drain filter (9). Clean the tank fil-
ters (7), the cover plate (12) and the level pipe (11).
Store the cleaned parts in a washing basket. Ensure that the rubber seal
(10) on the level pipe does not become deformed, by allowing it to hang
freely.
Turn the knob (1) to position 0. Remove tank filters (8) and the cover plate
(13) from the machine. Remove the level pipe (12). Leave the door open.
Turn the knob (1) towards the symbol (3), wait for 3 seconds, proceed to
the symbol (5) and keep it there until the drain pump will start and pump the
water in the washing tank to the drain. The drain pump stops automatically
after 2 minutes and 20 seconds.
Check that no objects have fallen and lodged in the machine.
Close the door and turn the knob (1) first to position 0 and then to position
(3). The internal rinsing process starts.
After around 30 seconds, open the door and turn the knob (1) towards the
symbol (3), wait for 3 seconds, proceed to the symbol (5) in order to empty
the rinsing water out of the machine. Then reset the knob to position 0.
Check that the washing and rinsing nozzles (14, 15) are clean.
Remove and clean the pump filter (9) and drain filter (10). Clean the tank
filters (8), the cover plate (13) and the level pipe (12).
Store the cleaned parts in a washing basket. Ensure that the rubber seal
(1) on the level pipe does not become deformed, by allowing it to hang free-
ly.
23
Rev. 3.0 (201308)