Table of Contents
Advertisement
STANDARD DOOR REMOVAL
Step 1 - Remove the standard entry door, by lifting
the door off the hinges. The standard door should be
removed if the full screen door has been installed.
Step 2 - The standard door is stored underneath
the rear sliding bed. The hinges
slide onto pins under the bed
(A). The door pivots under the
bed (B) and is held in place with
a fabric strap.
Set up is complete.
Auxiliary bunk lights and
fans (if so equipped)
Clip auxiliary bunk light or bunk light fan
assemblies to the appropriate bed bow
braces. To operate, insert the bunk light
or bunk light fan assembly connector into
the 12-volt power receptacle attached to
the ceiling. An individual manual switch
to control each interior light and ceiling
fan is provided.
Tent Tear Down
DO NOT push the beds or slideout in until all the Velcro has been
detached.
Push the bed (and slideout, if so equipped) in completely before beginning
to lower the roof; failure to do so before lowering the roof can damage
the tent components Your Extended Limited Warranty does not cover
this damage.
Step 1
Zip all the windows closed, close the roof vent and turn off any lights.
1.
2.
Roll the privacy drapes upwards by pressing both buttons on either side of the black
locks and drawing the locks upwards.
3.
Make sure all equipment is properly stored and will not obstruct the roof when lowered.
4.
If the bed does not close easily, inspect the bed cushions and tent canvas from the sides
looking for obstructions. Once the obstruction is located, correct it and try again.
Maintenance Record
Section 4: Vehicle Operation
Table of Contents
59
Hide quick links:
Advertisement
Table of Contents
