Jayco JAY SPORT 2018 Owner's Manual page 42

Section 3: Pre-Travel Information
Adjust the equalizing bars of the hitch assembly so that the tow vehicle and the trailer are
essentially level. A high hitch will transfer weight behind the axles and cause the vehicle
to fishtail. A low hitch will transfer additional weight to the hitch. Refer to the hitch
manufacturer instructions to adjust the weight-distributing hitch to the proper height.
If you have additional questions, consult with your dealer. Make certain your Dealer is
aware of the tow vehicle you are using so a compatible hookup is achieved. Depending on
the model, your required travel trailer hitch ball diameter is either 2" or 2-5/16" (consult
your dealer for assistance).
Travel Trailer Hitching Procedure
The following procedure will help to assist you in securely hooking up your recreation
vehicle to your tow vehicle.
1. Make sure the trailer wheels are blocked.
2. Turn the tongue jack crank to raise the travel trailer tongue above the hitch ball.
3. Open the coupler latch on the travel trailer hitch.
4. Back the tow vehicle into the proper position.
5. Turn the tongue jack crank to lower the coupler onto the hitch ball.
6. Close the coupler latch after it is completely seated.
7. Install the (customer supplied) weight distributing bars (equalizers) as directed by the
OEM.
8. Remove the dolly wheel or platform and retract the tongue jack to its maximum height.
9. Attach the breakaway switch cable to the tow vehicle.
10. Attach the safety chains.
11. Plug in your wire harness/connector plug from the tow vehicle to the travel trailer.
12. Walk around the RV to verify exterior lights are working correctly.
13. Remove the trailer wheel blocks.
NOTE:If an Atwood brake actuator is used with an equalizing hitch,
be sure the hanger chains hang between straight down and forward
up to 34°. Do not use less than 6-1/2" hanger chain length. For
optimum brake performance, hang chains forward 34°. Refer to the
manufacturer's owner's manual for more information.
Travel Trailer Weight Distributing System (Customer Supplied): This system provides
a more stable tow vehicle/RV combination as it will spreads the weight evenly to distribute
it to the tow vehicle front and rear axles and the trailer axle. Consult with your dealer for
information on requirements and operation of this system. Be certain your tow vehicle can
carry the hitch weight.
Travel Trailer Sway Control (Customer Supplied): Sway control devices are available to
reduce the sway produced by crosswinds, air displacement caused by other vehicles passing
you in transit, incorrect weight distribution, excessive speed, the RV tires dropping onto
the shoulder of the road, etc. The use of sway control will help to control the side-to-side
movement and keep sway in check. Consult your dealer for additional information.
34
Maintenance Record Table of Contents