Table of Contents
Advertisement
Bumper mount
The spare tire bracket can be released and extended down to
access a storage compartment at the rear of the trailer without
removing the tire.
To extend the tire down
1.
Remove the cotter key from the pin holding the tire
carrier in place.
2.
Remove the pin and extend the carrier away from the
trailer.
Always return the tire carrier to the upright position
and lock it in place while traveling.
To remove the tire from the tire carrier
1.
Remove the lug nuts holding the tire in place.
2.
Remove the support bracket from the bottom lug.
3.
Pull the tire from the tire carrier.
To install the tire on the tire carrier
1.
Place the tire on the carrier with the top lug bolt
inserted into one of the holes in the tire rim and the
bottom lug bolt in the center of the rim.
2.
Install the top lug nut.
3.
Place the support bracket over the bottom lug bolt
across the center of the rim.
4.
Install the bottom lug nut over the support bracket.
5.
Tighten the lug nuts securely before returning to travel.
Vinyl Tire Cover (If So Equipped)
Your tires are manufactured with components that cause "bleeding" onto the tire cover. To
prevent this, it is recommended to use a separator (garbage bag, paper, cloth, etc.) between
the tire and the cover.
Setting Up Your Recreation Vehicle
Position the RV as desired.
Level the RV (side-to-side). Leveling your recreation vehicle is important as the water
drainage systems are designed with proper slope and must be level for proper operation,
and the appliances perform best when level.
Block the wheels securely to prevent the RV from moving.
Maintenance Record
Section 4: Vehicle Operation
Table of Contents
Bumper Mount
49
Hide quick links:
Advertisement
Table of Contents
