Table of Contents
Advertisement
Section 4: Vehicle Operation
Step 14a – Lifter post covers
Velcro all fabric lifter post covers. Bottom edges
are straight and top edges are tucked under the roof.
Step 15 - Tent set up is complete. Make any
adjustments to the tent to assure optimum water
run-off. Check to make sure there are no areas of
the tent pulled too tight or in a bind.
SCREEN DOOR INSTALLATION
Step 1 - Unsnap the top of the door from the
fabric latches. The top of the door will hang from
the cables. These cables remain attached to the
door even after installation is complete.
Step 2 - Turn the clip in
the screen door bracket
to release the bottom of
the door.
The clip will
fit through the hole in the
bracket. Lift the bottom of
the door off of the rail and
lower to the floor.
Step 3 - Set the door down into the door frame.
Turn it at a 45° angle through the door opening.
The bottom of the door sits in the threshold channel
on the outside of the RV. Plastic clips are toward
the inside of the trailer.
Maintenance Record
Table of Contents
57
Hide quick links:
Advertisement
Table of Contents
