Table of Contents
Advertisement
Section 4: Vehicle Operation
Tent Set Up And Tear Down
Do not use the bed braces if they are bent or damaged. Contact your
dealer to replace any damaged brace(s).
Ensure all tent Velcro fasteners are securely fastened. Loose areas could
result in openings large enough for an infant, child or adult to fall through.
Never leave small children in the camper unattended.
If the roof limit cable is extended too high, the entrance door will not fit
properly and the lifter system and/or tent damage could occur
Bed Slide Maintenance
Lubricate the bed slides two times each year. Use only a silicone spray to avoid attracting
dirt and soiling the bed mats. Do not permit the spray to me into contact with the tent.
Tent Set Up
If you have questions concerning tent set up, contact your dealer or Customer Service. It is
possible to setup the tent alone, however it is faster and easier with two people.
Step 1 - Make sure the unit is level. Level front to back using the tongue jack. Leveling side
to side may require additional blocking under the tires. Lower the stabilizer jacks.
NOTE:: DO NOT use Stabilizer jacks to level the unit.
Step 2 - Unhook all roof latches.
Step 3 - The manual roof system is
located on the tongue of the trailer.
Attach the handle to the lift shaft and
crank it until the roof is raised.
52
Maintenance Record
Table of Contents
Hide quick links:
Advertisement
Table of Contents
