Overview - HEIDENHAIN TNC 620 User Manual

Manual Operation and Setup | Using a 3-D touch probe (option 17)

Overview

The following touch probe cycles are available in the Manual
operation mode:
Refer to your machine manual.
The control must be specially prepared by the machine
tool builder for the use of a 3-D touch probe.
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
Soft key Function
Calibrating the 3-D Touch
Probe
Measuring a 3-D basic rotation
by probing a plane
Measuring a basic rotation
using a line
Setting the preset on any axis
Set a corner as preset
Set a circle center as preset
Setting the centerline as
preset
Touch probe system data
management
For more information about the touch probe table, refer
to the User's Manual for Cycle Programming
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Page
663
673
670
677
678
680
683
See Cycle Program-
ming User's Manual
16
655