HEIDENHAIN TNC 620 User Manual page 163

Fundamentals, File Management | Creating and writing programs
Soft key/key Function
Set the selected word to zero
Erase an incorrect number
Delete the (clearable) error message
Delete the selected word
NO
ENT
Delete the selected block
Erase cycles and program sections
Insert the block that you last edited or deleted
Inserting blocks at any desired location
Select the block after which you want to insert a new block and
initiate the dialog
Saving changes
The control normally saves changes automatically if you switch
the operating mode or if you select the file manager. If you
deliberately want to save changes to the program, proceed as
follows:
Select the soft-key row with the saving functions
Press the STORE soft key
The control saves all changes made since the
last time you saved the program.
Saving a program to a new file
You can save the contents of the currently active program under a
different program name. Proceed as follows:
Select the soft-key row with the saving functions
Press the SAVE AS soft key
The control opens a window in which you can
enter the directory and the new file name.
Select the target directory if required with the
SWITCH soft key
Enter the file name
Confirm with the OK soft key or the ENT key, or
press the CANCEL soft key to abort
The file saved with SAVE AS can also be found in the file
management by pressing the LAST FILES soft key.
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
4
163