Presetting With A 3-D Touch Probe (Option Number 17); Overview - HEIDENHAIN TNC 620 User Manual

16
16.10 Presetting with a 3-D touch probe
(option number 17)

Overview

Refer to your machine manual.
The machine tool builder can disable presetting in
individual axes.
If you try to set a preset in a locked axis, the control will
issue either a warning or an error message, depending
on what the machine tool builder has defined.
The following soft-key functions are available for setting a preset on
an aligned workpiece:
Soft key Function
Presetting on any axis
Setting a corner as preset
Setting a circle center as preset
Center line as preset
Setting the center line as preset
With an active datum shift the determined value is with
respect to the current preset (possibly a manual preset
from the Manual operation mode). The datum shift is
included in the position display.
676
Manual Operation and Setup | Presetting with a 3-D touch probe (option number 17)
Page
677
678
680
683
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017