Fluke 6060B Instruction Manual page 77

INSTALLATION AND OPERATION
The "IO" command interrogates the Generator for its option complemeot. The returned
record contains three integers, separated by commas, that indicates configuration of
options. For the 6060B, the first number is always 6, which indicates that the Generator
being interrogated is in fact a 6060B. The two remaining numbers arc the sum of the
option related numbers as follows:
2nd Number
4
8
3rd Number
2
For example, "6,1 2,2" would indicate a 6060B with options -65 1 , - 1 30, and -830.
The "IR" command interrogates the Generator for rejected entry error status. (Sec Table
2-6 for a list of rejected entry codes.) The returned record is the sum of errors that have
been detected while processing IEEE-488 commands. The status is cleared when
interrogated with the "IR" command. The status can also be explicitly cleared with the
"CE" command and is also cleared on the "CL" command and the clear interface
messages DCL and SDC.
The "IT" command interrogates the Generator for the self-test results. Table 2-14. lists
the self-test error codes. The self tests are performed on the Generator power-up and can
also be initiated with special function 02.
The self-test results are reported in four fields which are explained in the table. Any non­
zero code ind icates that some tests failed. Further details of the self-test results are listed
in the Service Section. Table 2-14. shows the self-test error codes.
The "IU" command interrogates the Generator for the UNCAL entry status. (See Table
2-5 for a list of the UNCAL Error Codes.)
The "IV" command interrogates the Generator for its current software revision level. The
returned record is similar to the following:
"V l .O" <EOR> ,
This means that the software revision level is Version l .O.
2-56
- 1 30 High-Stability Reference Option
= -65 1
=
Low-Rate FM Option
16 - 1 32 Medium-Stability Option
=
-830 Rear Output Option
�
Table 2-14. Self-Test Error Codes
fREQ
-bbb
MO D
a a
aa - Mod u l a t i on (AM and FM) test res u l t s
bbb
- I f d i s p l ayed, i ndi cates t h e se l f t e s t d i d not complete
-
Frequency test r e s u l t s
c c c = D i g i t a l t e s t r e s u l t s
ddd - Amp l i t ude test res u l t s
AMPL
C C C
ddd