Fluke 6060B Instruction Manual page 130

I
I
I
I
48-1 . INTRODUCTION
The information in this section describes the general access procedures for the following
major module assemblies.
Front Section Assembly, A I
Rear Section Assembly, A3
Synthesizer Board, A2Al
I Output Board, A2A4
Attenuator/RPP Assembly, A2A5
VCO Board, A2A2
I
Access to other assemblies is straightforward; and therefore, other assemblies are not
detailed in this manual.
I
LOCATION OF MAJOR ASSEMBLIES
48-2.
The location of the major assemblies of the Signal Generator is illustrated in Section 8.
Information on exchanging modules is presented in Section 40.
I
AC CESS INSTRUCTIONS
48-3.
Access instructions for each module of the Signal Generator are provided in the following
I
paragraphs. Before performing any disassembly of the Signal Generator, remove the
power cord from the rear panel power receptacle and remove the exterior top and bottom
instrument covers.
I
To install the assemblies, reverse the disassembly steps. Be certain the pin connectors and
filter sockets a1e straight when replacing the boards.
I
48-4. Removing the Front Section Assembly, A1
I . Disconnect the MOD INPUT wire
front of the Attenuator module.
I
2. Disconnect the front panel display ribbon cable at the controller.
3. Remove the decals from both front panel handles. Removing the decals ruins
I
them; new decals should be installed to maintain a proper instrument
appearance.
I
The part number for the decal is listed in Section 5.
4. Remove the five flathead screws from each front panel handle.
g
Section 48
Access Procedures
at the module connector located at the
W I
49-1