Fluke 6060B Instruction Manual page 227

I
I
I
•
I
I
I
7A-1. INTRODUCTION
This appendix contains information necessary to backdate the manual to conform with
the earlier PCB configurations. To identify the configuration of the PCBs used in your
instrument, refer to the revision letter (marked in ink) on the component side of each PCB
I
assembly. Table 7 A-1 defines the assembly revision levels documented in this manual.
As changes and improvements are made to the instrument, they are identified by
I
incrementing the revision letter marked on the affected PCA. These changes are
documented on a supplemental change/ errata sheet which, when applicable, is inserted at
the front of the manual. To identify the configuration the PCAs used in your Generator,
refer to the revision letter on the component side of each PCA.
I
7A-2. BACKDATING INSTRUCTIONS
To backdate this manual to conform with an earlier assembly revision level, perform the
I
changes indicated in Table 7 A-1 . If this manual documents all PCAs at their original
level, no changes are necessary, and no changes will be indicated in Table 7 A-I.
I
I
I
I
I
I
I
I
Manual Change Information
Appendix 7A
7A-1