Fluke 6060B Instruction Manual page 67

INSTALLATION AND OPERATION
Example
IEEE-488 Command: "LM98"
Response:
"BOABAAAAPP
BPEAAABDAEEBBAGBLKKMP AC"<EOR>
Refer to Figure 2-7 for information on how to decode this learn string.
The syntax for the Learn Interface "LI" Command is as follows:
"LI" Memory Location Code: Learn String
The Generator stores the learn string in the memory location designated by the memory
location code. If the memory location specified is 99, the instrument is programmed to the
data sent in the learn string.
Example
To program the Generator to the Instrument Preset State:
"LI99BOABAAAAPP J MAAAKAAAAAAAABBOBK KAAAAAPECEAABPE
AAABDAEEBBAGBLKKMPAC"
Note that the binary learn string in this example is the same as the learn string returned
from memory location 98 which contains a record of the Instrument Preset State.
Instructions:
1 .
If
negative. Per f orm Step dfor negative numbers.
Example of Instruction I :
To convert hexadecimal number I E:
(Since the most significant digit is I , the number is not negative.)
2-46
J
MAAAKAAAAAAAABBOBKKAAAAAPECEAA
Convert the hexadecimal number to a signed decimal number as follows:
a. Multiply the most significant hexadecimal digit by
b. Add the next significant digit to the value obtained in Step a.
c. M ultiply the sum of Step b by 16, and add in the next hexadecimal digit until
the least significant hexadecimal digit has been added.
the hexadecimal number started with an
d. Subtract, 16 from the number raised to the power of the number of digits.
+
14
( l * 16)
= 30
16.
NOTE
8 F,
through the number is
I