Fluke 6060B Instruction Manual page 41

INTRODUCTION AND SPECIFICATIONS
Example
Recall the I nstrument Preset State (located in memory location 98). Change the
frequency parameter to 302 MHz, then store
location 06.
Loc a l :
Remote: "RC98,KF2,.ST611
Notes
I .
2. In local control, two data d igits must be entered to specify the memory location.
3.
4. int equals unsigned integer.
5. The sequence operation recalls the next higher memory location, starting from
6. While [SEQ] is pressed, the next memory location number is d isplayed and the
2-27. Modulation Entry
The following information describes how to preset the modulation index (AM depth or
FM deviation), internal modulation rate (400 or 1 000 Hz), and how to select the
modulation source (internal and/ or external).
The FUNCTION-DATA-UNIT method of selecting the modulation index is
summarized in the following command syntax. The indices may also be modified using
Bright-Digit Edit or Step Entry. Since there is only one modulation display, the
modulation index displayed is determined by the last modulation FUNCTION key
pressed.
Command Syntax
Select Function -- Enter Data - Select Unit
2-20
(RCLJ (9J (8J E D I T [ + J
The memory locations available for operator use are 0 1 through 50. Additional­
ly, the following special memory locations are available:
Memory location 00 contains a backup-memory location. After a recall (or
sequence) operation it contains the last front panel setting. After a store
operation, it contains the data in the stored memory location before the store
operation. Thus, a recall operation can be reversed by recalling location 00.
Memory location 98 contains the Instrument Preset State.
Memory location 99 contains the present instrument state.
The
recall or store is performed when the second digit is released.
The last memory location specified (used for sequence operations) is displayed
while the [STO] or [RCL] button is pressed.
the last memory location stored or recalled. No memory location need to be
specified. When the highest location is reached, the sequence starts over again at
location 0 1 .
memory location is recalled. This key is repeating.
the
new front panel setting in memory
[ + J [STOJ [QJ[6J
I