Fluke 6060B Instruction Manual page 49

INSTALLATION AND OPERATION
i
nc
part ludes typical timing data, provided as an aid to system programmers. This
information can assist in writing programs that have greater speed and efficiency.
The Generator can be used with any IEEE-488 controller in the normal addressed mode.
The following two additional modes are available for operation without a controller:
Listen-only mode
Talk-only mode
i
n
the l ste on
ln - l y mode, the Generator responds to all data messages on the IEEE-488
bus. In the talk-only mode
program another 60608 Generat
2-34. Setting Up the IEEE-488 Interface
Figure 2-S shows a 6060B Signal Generator connected to a
CONTROLLER
Figure
Use the following procedure to set up the Generator with the IEEE-488 lnterface option:
1 . Connect a standard IEEE-488 cable between the Generator and the IEEE-488
de ic e
v .
IEEE-488 Inter f ace signal
IEEE-488 cable
The
using an
this, use the left most address switch
2. Select the IEEE-488 address and m
a. For control of the Generator with a controller, set both the LISTEN ONLY
and TALK ONLY switches to 0 (down). Set switches al through aS to the
desired address O through 30. For example, for an address of I, set switches
a2, a3 a4, and aS to 0 (down), and set switch at to
b. for talk-only operation, set the TALK ONLY switch
c. For listen-only operation, set the LISTEN ONLY switch to I (up) and the
TALK ONLY switch to 0 (down).
3.
Verify the address and mode:
2-28
the Generator sends commands on the IEEE-488 bus to
,
o r (or a 607xA with some restrictions).
2-5. 60608 Signal Generator Connected to a 1 722A
NOTE
a metallic
SHIELD ( pin 12) can be disconnected (when
(as
with hood ) f rom instrument ground. To do
viewed from the rear panel).
o
d e as follows:
1 722A
via the I E EE-488 bus.
60608
I
(up).
to I
(up).
I
I
E
I
I