Replacing The Batteries; Caring For Your System - i-SENS CareSens N Owner's Booklet

Replacing the Batteries
The CareSens N meter comes with two 3.0 V lithium batteries.
When the icon appears on the display for the first time, the
battery should be replaced as soon as possible.
The test results might not be saved if the battery runs out.
Step 1
Make sure the meter is turned off. Push the
cover in the direction of the arrow to open
the battery compartment.
Step 2
Remove the old battery by lifting the
battery with the index finger and pulling
out the battery with your thumb and index
fingers as shown in the figure on the right
one by one. Insert two new batteries with
the + side facing up and make sure the
battery is inserted firmly.
Step 3
Place the cover on the battery
compartment. Push down until you hear
the tab click into place.
Note:
Removing the meter batteries will not affect your stored
result. However, you may need to reset your meter settings.
See pages 12 ~ 14.
38 www.i-sens.com
Caring for Your System
Use a soft cloth or tissue to wipe the meter exterior. If necessary,
the soft cloth or tissue might be dipped in a small amount of
alcohol.
Do not use organic solvents such as benzene, or acetone, or
household and industrial cleaners that may cause irreparable
damage to the meter.
Store all the meter components in the portable case to prevent
loss.
Caution:
• Do not expose the meter to direct sunlight or heat for an
extended period of time.
• Prevent the entry of dirt, dust, blood, or water at the meter's
test strip port.
• Do not drop the meter or submit it to strong shocks.
• Do not try to fix or alter the meter in any way.
• Keep the meter away from strong electromagnetic fields
such as cell phones and microwave ovens.
• CareSens N meter should be used only with CareSens N
strips.
• Keep the meter in a cool and airy place.
www.i-sens.com 39