First Alert FA848C Installation And Setup Manual page 60

NOTE: All auto arm modes will force-arm the system. This means any open zones at the
time of auto arming will be bypassed. To report these bypassed zones, program a bypass
code in submode 2, Question 80, L1.
Q 33, L4 Up and About Enables
L4
Entry
0
1
2
3
4
5
6
7
Up and About: If no controlled zone is violated within a 24-hour period (beginning at
midnight), a signal is sent to the central station. This can serve as a safety feature for
elderly, infirm, or disabled persons.
Q 34-36 AUTO ARM TIMES
These questions set the auto arming time for each partition.
L1/L2: Enter hour 00-23 by entering the first digit of the hours (0-2) in L1 and the second
digit (0-9) of the hours in L2. (00 = 12 midnight)
L3/L4: Enter minute 00-59 by entering the first digit of the minutes (0-5) in L3 and the
second digit (0-9) of the minutes in L4.
For example, to set an auto arm time of 11:35pm, enter 2 in L1 and 3 in L2, then enter 3 in
L3 and 5 in L4.
Q 34 AUTO ARM TIME PARTITION 1
Q 35 AUTO ARM TIME PARTITION 2
Q 36 AUTO ARM TIME PARTITION 3
Q 37-48 TRIGGER/RELAY TYPES
These questions set the relay type for relays and triggers. Momentary trigger times in
seconds or minutes for each partition are set in Questions 70 and 71.
Each trigger definition requires 2 locations to define its operation. L1 defines the partition in
addition to the type that the trigger is to respond to. L2 completes the type definition entry.
Some triggers types are not partition-independent functions, such as loss of AC. Triggers
that are momentary can follow either a second timer or a minute timer as described for that
trigger type. Each partition has both a minute and second programmable time. Note that all
momentary triggers for a partition will follow the momentary time (seconds or minutes)
programmed for that partition. Each timer may be programmed for 1-15.
6-28
Up and Up and
About Part. 1 About Part. 2
Up and About
Part. 3
L1 L2 L3
hours minutes
L1 L2 L3
hours minutes
L1 L2 L3
hours minutes
L4
L4
L4