Table of Contents
Advertisement
Data Entry Via Keypads
This section describes the physical keystrokes necessary to perform keypad programming
and how to interpret the data displayed on the LED based keypads and on the LCD keypads
during programming operations.
NOTE: Actual keypad programming should be performed only after completion of the
programming sheet.
How To Enter Programming Mode
The SYSTEM programming mode can be entered WHILE DISARMED ONLY as follows:
TO ENTER INSTALLER PROGRAMMING: [CODE] [ ] [INSTALLER] [1], then select the
programming submode 1-4 from the prompt (shown below).
1=System 2=Zones
3=ZR401 4=Descr
Where:
[CODE]
[ ]
[ INSTALLER]
[1]
† user/installer codes can be 4 or 6 digits, as set in Question 17, L3.
Installer Mode 1 Submodes:
1 = System Options
2 = Zone and All Central Station Report Code Programming
3 = Wireless Zone/Keyfob Programming
4 = Zone Descriptor Programming
What You See on the LCD Keypad
Upon entering the System Options submode, the following display appears on the LCD
keypads:
Q#: 01 M1 Edit
DATA: 1234
The display shows:
Q# = the current question number
M1 = the submode number
L: = the location within the question
DATA: = the current value within that location
System = the submode title
Movement Between and Within Questions
Random jumps to a specific question: Press the
Sequential to next question:
Accept data entry and move to
Next data location in question:
Switch Submode:
Press the CODE button
Press the star (∗) button
Enter the 4 or 6-digit † installer code (default = 2468)
Press "1" button. This indicates Installer Mode 1.
L:01
System
digit question number.
Example: Jump to question 07= Press
Press the [INSTANT] button
Press [#]
Press [∗] [BYPASS] then select submode from prompt
(star) button followed by the desired 2-
0 7
6-5
Advertisement
Table of Contents
