Table of Contents
Advertisement
This section defines the programming questions and the values for each question. You
should complete the SYSTEM PROGRAMMING WORKSHEET (insert) before entering data.
Installer Mode 1, Submode 1: SYSTEM OPTIONS
Enter Installer Programming mode, then press [1] at the submode prompt to enter System
Options mode.
QUESTIONS 01-06 TELEPHONE and PAGER NUMBERS
Enter the telephone number (including area code and/or dialing prefix IF NECESSARY) of
the primary central station receiver in Question 01, L1 – L20.
Example: If the primary telephone number to be entered is: 1-516-921-6704,
you would enter (on Programming Worksheet): 15169216704.
Enter the valid digits from the table below.
Entry
0-9
A
B
C
D
E
F
REPORTING ROUTE:
The system can report to 1 or 2 central station phone numbers. If split reporting has been
selected then OPENING and CLOSING signals will be directed to the secondary phone
number while all other signals will be transmitted to the primary phone number. If backup
reporting is selected, the panel will alternate between the primary and secondary receivers
(if the second phone number is programmed) for a programmable number of attempts
(Question 16, L3) to each phone number in the event the signal has not been acknowledged.
If dual reporting is selected, then signals are sent to both primary and secondary phone
numbers. If neither split or backup reporting is necessary then this question may be left as
factory defaulted and all conditions will be routed to the Primary number only.
Enter the telephone number (including area code or dialing prefix IF NECESSARY) of the
secondary central station receiver in Question 02, L1 – L20. An entry of the digit A skips
that digit and system will examine the next digit.
Q 01
PRIMARY TELEPHONE NUMBER
Q 02
SECONDARY TELEPHONE NUMBER
Q 03
CALLBACK TELEPHONE NUMBER
Enter the telephone number (including area code or dialing prefix if necessary) for this
control panel to reach the callback number location . The callback number is the optional
location of the Downloading Software where the control panel will call during a remote
communications (upload/download etc.) session. During remote communications the
programming device and the control panel will first confirm the CS security code. If valid,
communications can begin. If a callback number is defined, the control panel will hang up
and dial the callback number. For no callback capability enter "A" in L1-L20.
Function
0-9
Signifies end of the phone number
Star ( )
3 Second pause
Pound (#)
70C (Touch-tone)
1170C (Rotary)
800
Comments
Enter after last digit of phone number
Enter whenever the star is used
Provides delay to wait for dial tone
Enter whenever the pound is used
Enter to disable Call Waiting
Enter to dial 800
6-7
Advertisement
Table of Contents
