First Alert FA848C Installation And Setup Manual page 53

Keypad Extinguish: If selected, the keypad display and LEDs will turn off after 1 minute
of no key presses.
Keyfob Low Battery Display: This option determines whether low-battery messages from
keyfobs will be displayed. If selected, display is enabled. Note that even if this display is
disabled, keyfob low battery conditions can be checked by using the #56 Quick Command.
Q 21, L3 This location selects the type of clock displays. Enter the L3 digit from the table below.
L3
Am/Pm 24hr
Entry
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Clock: Shows time in military time 00-23 hours. Otherwise 1-12 hours with A or P.
Day/Month: Time displayed as day then month (23, Feb. 1990) , otherwise, as US standard
(Feb. 23, 1999).
NOTE: Clock set is always entered as 24-hour time, with order the same (in case LED.) See
quick command [#][3].
Display Time: LCD only; displays time during status scroll on line 2, the last six digits.
NOTE: The partition descriptor should be limited to 10 characters when time is displayed
or it will be overwritten by the time.
Display Clock Fail: LCD only; if the system goes through a hardware reset (loss of all
power or watchdog reset), the clock will not be correct and a message will be displayed
indicating this.
Language Select: This location selects the language for the keypad display as follows:
Q 21, L4
0 = English
1 = Italian
2 = Spanish
Clock Day/Month
mm/dd dd/mm
3 = French
4 = Dutch
5 = Portuguese
Display Time Display Clock
Fail
6-21