Table of Contents
Advertisement
To Add Or Change Users:
[CODE KEY] [MASTER USER CODE] [USER no.] [NEW USER CODE] [AUTHORITY LEVEL]
where:
[CODE KEY]
[MASTER USER]
[USER #]
[NEW USER CODE]
[AUTHORITY LEVEL] The desired authority level for the new user.
*(depending on the whether the system is set for 4 or 6 digit security codes)
Example: Define user number 03 with a code of 7493 and authority level 3. (Assume master
code is 1234) = CODE 1234 03 7493 3
An acknowledgment sound (steady tone) verifies a successful user code programming. A negative
acknowledgment sound (4 short tones) indicates unsuccessful programming. If additional user
programming is necessary, repeat the procedure listed above. If a dialing format is programmed
which transmits opening/closing by user ID, each user will report their user number.
Assigning Partitions and Pager Open/Close Reports to Users
Users are automatically enabled for the partition where their code was added. You can also
allow users to access other partitions and/or enable open/close pager reports for a user by
using the #7 command as follows:
[#][7] [master code] [user no.] [1, 2, 3, or 4]
where:
master code
user no.
1, 2, 3, or 4
To exit this mode, press [∗].
User code programming can ONLY be performed while the partition is DISARMED.
User Deletion
User codes (02-64) can be deleted from any disarmed partition's keypad, regardless of where
the user's code was first added. Once deleted their values will be null.
TO DELETE USERS: [CODE] [MASTER CODE] [USER no.] [ ]
where: [CODE]
Press Code button on keypad.
Enter 4 or 6-digit* Master User code (user with authority level 1 or 2)
Enter Desired user number to be programmed (01-64).
Enter 4 or 6-digit* user code for the new user. Valid digits are 0-9.
user with authority level 1 or 2
the user that will be assigned access to other partitions
select 1, 2, 3 to assign access to a partition to that user
select 4 to enable open/close paging report for that user
Press CODE button on keypad.
Enter Master User code.
[MASTER CODE]
Press the desired user number being deleted (02-64).
[USER #]
[∗]
Press the
(star) button.
5-7
Advertisement
Table of Contents
