Adjusting The Seat Height And Seat Angle - Vermeiren Eclips+ 30 Instruction Manual

3.3

Adjusting the seat height and seat angle

WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
WARNING:
Risk of tipping over - When the driving wheels are adjusted, the
position of the wheels are altered.
The Vermeiren Eclips+ is adjustable in 4 seat heights and different seat angles by changing
the wheels position. The Vermeiren Eclips+ 30° are adjustable in 3 seat heights 470 - 530
mm and different seat angles by changing the wheels position. At each height there is a
different setting of the front and rear wheels.
The summary of the different seat heights by a standard seat angle 7° is tabulated below.
Seat height
430 mm
470 mm
500 mm
(Standard)
530 mm
Change the seat height and seat angle according the following steps (refer to the figure on
the next page):
* Front wheel:
1. Loosen the screws
2. Choose correct size for the adapter
3. Place the steering wheel adapter in the desired position.
4. Tighten the screws
5. Change diameter of the steering wheel if necessary
* Rear wheel:
6.
Remove the rear wheels (see § 2.13).
7. Loosen the fixing screws
8. Push the axle block
9. Tighten the screws
10. Mount the rear wheels.
11.
Adjust the brakes according § 3.8.
Rear wheel
Ø Holes
22" Hole 9 and 11 200 mm
24" Hole 8 and 10 140 mm
24" Hole 6 and 8 200 mm
24" Hole 4 and 6 200 mm
Table 3: Seat heights Eclips+
from the steering wheel adapter
and fork.
properly.
from the rear axle block
upwards or downwards to the desired height.
properly.
ƒ‰‡
Eclips+, Eclips+ 30°
Front wheel
Ø
Adapter /
fork
Short
Standard
Standard
Standard
.
(only for seat height 470 mm).
.
2011-06
Holes
Hole 2 and 3
Hole 2 and 3
Hole 2 and 3
Hole 1 and 2