Table of Contents
Advertisement
Available languages
Available languages
3.5
Anatomical seat
3.6
Flexible back (Eclips+)
WARNING:
Risk of injury - Make sure that all screws are properly tightened
before using the wheelchair.
1
3.7
Anatomical back
WARNING:
Risk of injury – Check that the backrest is secure before use.
WARNING:
Risk of injury – Avoid getting your fingers caught during the
assembly process.
3.8
Adjust the brakes
WARNING:
Risk of injury – Brakes may only be adjusted by your specialist
dealer.
Adjust the brakes according following rules:
If you have opted for an anatomical padded seat, place it on
the tubular cross-hinge so that the seat's supports engage
equally with the cross-hinge. In the wooden base you will find
slots that are placed in the hinge's cross-pieces. To fold up the
wheelchair, remove the seat by pulling it upwards.
The height of the back can be adjusted by setting the
entire back tube.
For adjusting the height of the back cover, loosen the
fixing screws c behind the back tube. Then you can
move the cover upwards or downwards. There are fixing
holes every 20 mm in the back tube where the screws
can be retightened.
To use the anatomical backrest, proceed as follows:
1. Unscrew the flexible backrest.
2. Loosely screw on the brackets for the backrest.
3. Insert the backrest into the brackets from above.
4. Tighten the screws holding the brackets for the
backrest.
5. Insert and tighten the safety screws for the
backrest.
6. Add the armrests.
1. Install the wheels according § 2.2.
2. Disconnect the brakes by pulling lever
backwards.
ƒ‰‡
Eclips+, Eclips+ 30°
2011-06
c
Advertisement
Chapters
Table of Contents
