RAM Promaster 2016 User Manual page 75

MESSAGE
Gear Not Available
Shift Not Allowed
Press Brake Pedal And
Try Again
Shift To Neutral
Press Brake Pedal
Press Brake Shift to N
key to start
Parking The Vehicle
To park safely, it is essential to engage MANUAL (1st) gear, DRIVE (D) or REVERSE
(R) gear while your foot is on the brake pedal. Once MANUAL (1st) gear, DRIVE (D)
or REVERSE (R) gear is displayed in the EVIC, turn the engine off and engage the
parking brake. It is essential to wait until the gear engaged appears in the display
before turning the engine off and releasing the brake pedal. Always remember to set
your parking brake.
NOTE:
NEVER leave your vehicle with the gearbox in NEUTRAL (N) and always remember to
fully apply your parking brake. Always remember to set the parking brake when the
"Set Park Brake" message is displayed.
This message appears, along with a warning buzzer:
• When it is not possible to change gear due to a fault in the
system.
• When, due a fault in the system, it is only possible to
engage 1st (1), 2nd (2), 3rd (3) or reverse (R).
Contact your authorized dealer if the message continues to
appear.
This message appears, together with a warning buzzer, when
the system will not allow a gear change requested by the
driver (for example, that would cause engine overspeed or
transmission damage).
This message may also appear when starting the engine at
low temperature. In this case the Automated Manual trans-
mission isn't able to engage first gear, in this situation ei-
ther use the engine block heater or allow the engine to idle
in NEUTRAL (N) until the transmission has warmed.
This message appears accompanied, in some cases, by a
warning buzzer, if you attempt to change gear with the ve-
hicle parked without pressing the brake pedal.
To shift the transmission (with key on/engine off), press and
hold the brake pedal, move the shift lever to NEUTRAL (N),
then move the shift lever to the desired position.
This message appears, together with a warning buzzer, when
the shift lever must be moved to the NEUTRAL (N) position.
When the shift lever is moved to NEUTRAL (N) the message
on the display should go off.
Contact your authorized dealer if the message continues to
This message is shown in the display together with an
acoustic signal, when the brake pedal is not pressed during
This message appears, after opening the driver's door, to
remind you to press the brake pedal and shift the lever to
NEUTRAL (N) to permit engine cranking.
DESCRIPTION
appear.
a starting attempt.
D I E S E L
73