RAM Promaster 2016 User Manual page 17

Installing Child Restraints In Commercial Vehicles
This commercial vehicle is not designed for use as a family vehicle and is not
intended for carrying children in the front passenger seat(s). Never install rear-facing
child restraints in this vehicle. Although the seat belt can be locked to secure a child
restraint, there are no tether anchorages to complete the proper installation of a
forward-facing child restraint. If you must carry a child in a forward-facing child
restraint, the passenger seat should be moved to the full rearward position and the
child must be in a proper restraint system based on its age, size and weight. Follow
the instructions below to secure the child restraint using the seat belt.
Rear-facing infant restraints must never be secured in the passenger seat of a
vehicle with a passenger Air Bag. In a collision, a passenger Air Bag may deploy
causing severe injury or death to infants riding in rear-facing infant restraints.
Installing The Child Restraint Using The Vehicle Seat Belts
The seat belts in the passenger seating positions are equipped with a Switchable
Automatic Locking Retractor (ALR) that is designed to keep the lap portion of the
seat belt tight around the child restraint. Any seat belt system will loosen with time,
so check the belt occasionally, and pull it tight if necessary.
To install a child seat using an ALR:
1. Pull enough of the seat belt webbing from the retractor to pass it through the belt
path of the child restraint. Do not twist the belt webbing in the belt path.
2. Slide the latch plate into the buckle until you hear a "click."
3. Pull on the webbing to make the lap portion tight against the child seat.
4. To lock the seat belt, pull down on the shoulder part of the belt until you have
pulled all the seat belt webbing out of the retractor. Then, allow the webbing to
retract back into the retractor. As the webbing retracts, you will hear a clicking
sound. This means the seat belt is now in the Automatic Locking mode.
5. Try to pull the webbing out of the retractor. If it is locked, you should not be able
to pull out any webbing. If the retractor is not locked, repeat the last step.
6. Finally, pull up on any extra webbing to tighten the lap portion around the child
restraint while you push the child restraint rearward and downward into the
vehicle seat.
G E T T I N G S T A R T E D
WARNING!
15